The most affordable and versatile vehicle-mounted traffic signal
preemption device on the market. Small, lightweight,
and waterproof, this power pack will drive nearly
any strobe including (but not limited to) deck and windshield
strobes, visor-mounted strobes, PAR-36 and most lightbar strobes,
headlamp strobes, grill strobes, etc. Ranges to 2500 feet (NOTE:
actual operational range depends upon the strobe emitter, mounting
location, and the sensitivity of the traffic signal preemption
receiver).
The ExtremeRange™ Mode
doubles the output power delivered to the strobe, significantly
increasing the operating range of the MicroMount.
Quickly and easily installs in most lightbars, engine compartments,
or any cramped space. Installation time and expense is significantly
decreased by eliminating lengthy cable runs between the strobe
and power pack.
A detachable mounting plate (included) increases mounting
location options. User-selectable disabling features shut down
the output when the transmission is placed in park or the emergency
brake is engaged.
Who uses the MMER:
Police; Fire Police; Paramedic and Ambulance Personnel; HazMat
Personnel; Traffic Signal Installation, Maintenance, &
Repair Personnel; State and Federal Law Enforcement Officials;
State and Federal Motorcades; Funeral Homes (for processions)
etc.
Specifications
Electrical specifications
- Power Supply Requirements: 9 to 15 VDC 2.0 amps nominal,
4.0 amps maximum (ExtremeRange mode of operation); mounts
directly to positive or negative grounded vehicles; internally
fused
- Selectable transmission/brake disabling feature
- Flash Rate: 14.035 hz +/- 0.0025 hz; crystal controlled
(10 hz Low Priority flash rate available upon request)
Mechanical specifications
- 5.75"(L) x 2.10"(W) x 1.20"(H) dimensions
w/o mounting plate (6.75"(L) w/mounting plate)
- 16 ounces (without mounting plate)
Accessories & options
- Pre-assembled 15’ strobe extension cable and connectors
- Strobe emitters
Package contents
- Detachable mounting plate
- Power cables, switch, and connectors
- 12” strobe emitter cable and connector
Warranty
|
